User
Write something
DIY HVAC Academy Monthly Q&A is happening in 21 days
I fixed my AC by watching your YouTube
I've watched a lot of your HVAC videos. I've learned so much from your channel that I now feel confident I could replace an entire AC system myself—and do it the right way. When I inspected the original system that came with my house, I discovered it didn't even have a filter drier installed. Amazingly, it still worked for more than 25 years. Eventually, it developed a refrigerant leak because the liquid line was rubbing against the brick where it exited the house due to vibration. I was able to repair the leak and install a filter drier because of what I learned from your videos. I really appreciate your enthusiasm for teaching and the time you put into creating such educational content. Keep up the great work!
Before Replacing the HVAC, I Fixed the House—and It Worked
I wanted to share a DIY HVAC success story from our home in Central Florida. We have a 1,775-square-foot house with a 3-ton, single-stage Bryant system. For a long time, the house never seemed to perform as well as it should. The AC would run short cycles, humidity was inconsistent, some rooms were uncomfortable, and the system seemed to struggle even though it was technically cooling. Instead of immediately replacing the equipment, I started collecting data. I installed an Ecobee thermostat and placed multiple temperature and humidity sensors throughout the house, including the bathrooms, bedrooms, living areas, garage, and attic. I also used a thermal camera, an anemometer, a manometer, and temperature probes to start identifying where the house and duct system were losing performance. Here is what we found: • Several supply registers and return grilles were leaking air around the drywall openings. • The fireplace chase was open to the attic and allowing hot, humid attic air into the conditioned space. • Bathroom exhaust ducts and exterior terminations had damper and sealing issues. • The kitchen range hood had been running continuously and was depressurizing the house. • Some attic insulation had been disturbed or compressed. • The AC blower speed had a major effect on both temperature control and humidity. • The garage door, wall penetrations, and other envelope areas also needed attention. We sealed the supply and return openings, sealed the fireplace chase from above and below, corrected the bathroom exhaust venting, installed proper exterior dampers, sealed penetrations, and stopped running the range hood continuously. We also tested different blower settings instead of assuming the highest airflow was automatically best. The results have been significant. The house now feels noticeably colder and more comfortable at the same thermostat setting. The AC cycles are more stable, room-to-room temperatures are more consistent, and the humidity is under better control. We are comfortable around 72°F without needing a separate whole-house dehumidifier.
Homeowner
I'm 87 but still active. I'm a DIY person and have installed my own solar system and just finished installing a 1 ton mini split that cost me $550.00 on Amazon. It is great. I have two Heat Pumps on my house in Yuma, AZ. I just added a soft start to one. Always can use help when something goes wrong with one of those units. I can also help anyone that wants to install a mini-split or soft start.
1-3 of 3
The DIY HVAC Community
skool.com/diyhvac
Welcome! This community is a great place to get answers to your DIY HVAC questions, see other peoples success stories, and just learn more about HVAC!
Leaderboard (30-day)
Powered by