Slow, but progressing · Circular Machine Knitting Addi

Slow, but progressing

I’ve decided if I ever do another weaving project like this, I will get a 24” x 18” wooden board and drill holes in it around the edge. I’ll add removable finishing nails as the pins around the edge. Then I would then stretch one long cord back-and-forth (zig zag) across those pins vertically. Afterward I would weave each single horizontal iCord, using the finishing nails to pin them in place.

I’m doing all right using these foam blocking boards, but I have to be careful because they’re so flexible. They tend to curl upward a little when I pull the iCords snug. As you can see, I have the long edge finished and sewn to hold from slipping apart. And I am working horizontally now. Yes, the iCord ends are all uneven, but when I get to the point of finishing, I will trim and tie them off before stitching the edge down.

I definitely have way more iCord finished than I will need! lol Hopefully my next update will have the finished project.

8 comments