Jul 16 (edited) • Cummins VE12 valve
Block Clearances with ARP studs - General info
I’ve emotionally pulled the trigger on some ARP 14mm main studs. I was hoping that they wouldnt mess up my bore much, but check out the results.
Before ARP with OEM bolts
Vertical - 3.4639
Horizontal - 3.4650
After ARP
Vertical - 3.4631
Horizontal - 3.4650
Can I run this if my oil clearances are ok? I did a rough measurement and they’re about 0.003 which is in spec
1
10 comments
Block Clearances with ARP studs - General info
Leaderboard (30-day)
1
+37
2
+28
3
+17
4
+9
5
+9
Powered by