Looking for a little advise on material thickness. I would like to build this display to go on top of my bar cabinet. I will be using 1 in sq tubing mild steel, might order it pickled if not too much more $$$ but struggling with thickness for 2 reasons, weight and cost. This will be a Tig project as my mig will not see this. 😁. Let me know your thoughts on material thickness, tungsten color and size, cup type and size, and amps please. Thank you

I have been struggling with this so much on our two ck20 torches! I put a 30x close up of the weld. https://www.facebook.com/share/p/1FyEuWaCUq/ https://youtu.be/yD0n-hrhzoI?si=FAgSSQQVSqE4gEhs

Hello if someone is interested in good quality controller Will provided everything only thing the stepper motors will need to be replaced last they were two of them were binding yes its a used system works will provide laptop and all components.

150amps with pedal. 3/32filler and tungsten. 140hz. 32 AC Balance. 7 L/min

Just wondering if anyone has had issues with building this Kit in metric measurements IE 4 inch beam = 101.6 mm 2 inch = 50.8mm and where I am located in Australia being a metric country. Everything is 25,50, 75 and 100 mm. I understand the common recommendation is to purchase a table from a supplier like lanngmuire or other brand. Unfortunately due to shipping costs that isn't really a viable option and the cheapest option that is any sort of decent quality here is 10k and only is capable of cutting half sized sheets. Any info would be appreciated thank you