In this post:
- The third interview, and why it is the only one with a veto.
- The four-second math your best tech ran before the new guy's first oil change.
- Why your worst technician always volunteers to train the new hire.
- The one question that tells you whether your crew is right or whether this one is on you.
- Three moves before the next hire's first day. All free.
4 min read. Short on time? Watch or listen to the walkthrough below.
____________________________________
"He wasn't a culture fit."
You have said it. So has the shop down the road.
It is almost always wrong.
There is a third interview in every hire. Nobody tells you about it.
You interviewed him. He interviewed you, whether you noticed or not.
Then your crew interviewed him. After he was on payroll. After he was already standing in a bay with a repair order in his hand.
That third one is the only interview with an unappealable veto.
It is also the only one you never scheduled.
You can overrule your advisor. You can overrule your own gut. You cannot overrule the guys in the bays once they have quietly decided this is not going to work.
The crew does not have to say a word to reject someone. They only have to withhold.
Withholding does not look like conflict. It looks like a normal week.
Nobody mentions the lift that has to be babied.
Nobody tells him which customer will call back twice.
Nobody walks him to the parts bin, so he spends nine minutes finding it, twice a day, for three weeks.
Nobody tells him which promise time is real and which one the advisor made up to get off the phone.
He is not being run off. He is being left alone. So he is slower than the guy he replaced, and he knows it, and nobody will tell him why.
Seventy days later he is gone. You decide the applicants were bad. You run the ad again.
You have been reading that as a people problem.
It is arithmetic.
In a flat rate shop, a new tech is not neutral. He is a claim on the same pool of hours.
Until car count grows, every hour he flags is an hour somebody else did not.
Hourly shop, same math. The pool is the good jobs, and there is a finite number of good jobs on the board.
Your best tech ran that math before the new guy's first oil change. He ran it in about four seconds. And if you had not shown him the numbers, he ran it with whatever he made up.
He does not know what you turned away last month. He does not know how much declined work is sitting in your system right now. He knows what he flagged last week, and he knows there is a new set of hands in the building.
So the coolness on the floor is not personality. It is a man protecting his paycheck with incomplete information.
He is not being difficult. He is doing math with missing numbers.
You are the only person in that shop who has the numbers.
Somebody has to teach the new guy. In a flat rate shop, that somebody loses money doing it.
Every question is a stopped clock. Every walk to the parts bin is unflagged time. Every time he stops to check the new guy's work, he pays for it out of his own week.
Nobody put that on a pay plan. It comes out of one man's paycheck and it goes on nobody's books.
Your best tech avoids the job, because he has the most to lose per hour.
Your least productive tech volunteers, because he has the least.
Your new hire learns the shop from the person who represents it worst.
Then he ramps slow, and everyone decides he was a bad hire.
You cannot ask a man to train his competition for free.
A tech who has trained three people who did not last has spent three ramp cycles absorbing extra work with nothing coming back. Three times he covered. Three times he explained the same lift. Three times he watched the guy clean out his box.
By the fourth, he does not invest on day one. He waits to see if this one sticks.
That waiting is exactly what keeps him from sticking.
The resistance you are reading as attitude is grief from the last three.
Nobody in your shop is being difficult. They are protecting themselves from a fourth round of caring about someone who leaves.
Sometimes the crew is right and the hire is genuinely bad. That happens.
Ask the tech who is complaining one question.
Give me one job he got wrong and the date he got it wrong.
If he can produce it, believe him. That is a work signal. Go pull the repair orders and look at the comebacks yourself.
If the answer is a category instead of an incident, then it is not about the new guy at all.
Attitude. Does not fit. Something about him.
Those are not observations. Those are conclusions with the evidence removed.
Vague rejection is almost never about the person being rejected. It is about the conditions he was dropped into.
That is the same phrase you used about the last one.
Three things before the next hire's first day. All free.
1. Show your crew where his hours come from. Pull the declined work from last month and convert it to hours. Not a promise about growth. A number they can stand there and read.
2. Name one person as the trainer, pay him for it, and put an end date on it. Say the number out loud. An hour of flag time a day for four weeks is a real one. Add a bonus if the new guy is still there at ninety days.
If you have never named a trainer out loud, you already named one. Your crew picked him, and they did not pick your best.
3. Tell your crew about the ad before they see the ad. They will see it. They are in the same groups you are advertising in.
If you only do one, do the second one. It is the cheapest money you will spend all year.
Post your number below👇