Oct '24 • 🗣 General Discussion
1.2 Hammer
I am trying to isolate a part on this however this option doesn't come up in the table. I suspect it may be something to do with this.
Can someone tell me the difference between these two symbols. I think one means it is fully dimensioned the other I am not sure I have wondered this for a while. The two pictures are attached below.
5
10 comments
1.2 Hammer
skool.com/solidworks-accelerator
Learn SOLIDWORKS Fundamentals in just 14 days.
Leaderboard (30-day)
1
+4
2
+2
3
+2
4
+1
5
+1
Powered by