I’m using unbound with encrypted forwarding.

Just surge protectors, nothing else.

I did my upgrade last night following your guide and the official docs. It went without a hitch. Thank you.

There are plenty of 10” rack mount kits and parts on Makerworld, and other repos. They all look very interesting.

@Amrut P could go this route too and 3D print everything else. https://a.co/d/iUpFxBT

@Simon Varlow explain?

@Simon Varlow You may have a jam in the heat break. If you remove the nozzle, the filament should pass through with no problems while cold, no need to heat for this. If not, you have something stuck in there. Try heating it without the nozzle attached and use a small Allen key or wood rod of appropriate diameter to clear the jam. I would remove the Bowden tube from the top of the print head and gently push down through the hole to clear. Careful not to burn yourself. With the tube and nozzle removed you should be able to see all the way through.