Most guys get hurt on springs not because they're careless — but because they were never taught a system. Here's the one thing that changed how I approach every spring install: Wind with a process, not with confidence. Confidence gets people hurt. A repeatable process keeps you safe every single time. Before I touch a winding bar or winding tool, I check three things: Are my cables seated properly in the drums? Is my vise grip set on the track below the bottom roller? Do I know the turn count for this door? That last one trips up a lot of new techs. The turns aren't always guaranteed — the manufacturer puts them right on the hardware box, however with Clopay doors specifically I have found that they are not always spot on. Any time I wind springs I will put 1 turn less than recommended and tune the door accordingly based on feel. Wind your springs, Gate your springs. Check your tension at waist height. That's it. The door should float. Not fly up, not drop hard — float. If it doesn't, you adjust. Half turn at a time. One side at a time. Springs aren't scary when you have a process. They're just the most important step on the job. Drop a 🔧 in the comments if this helped, and reply with any spring questions — I read every one.