Just wanted to drop here the company from China that helps us make most of the parts for these prototypes. They made 1.3-meter-wide copper hemispheres 1.5mm thick, and 80cm ones, and 50cm ones . All of them you can see on the images. They also cut for us the copper triangles for the Stela Octangula. They cut a few of the copper discs for the antigravity device. The bearings and the couplers, shafts, copper rods, and other parts come from this supplier in China: https://demark.en.alibaba.com/ They have great communication, reasonable shipping, and very good prices for the parts.

Both the primary and the output coils are around the connes equatorial plane. Both Have 4 windings. Tou can see that the slayer circuit have just one resistor amd one Transistor and I swapped the resistor value to change and smooth the AC pulses starting from 2.7 kOhms like in this video going to 9 kOhms then 20,50,10,220 kOhms then 1mOhm and even 2 mOhms and the circuit was working. At the end I just realized that even the resistor is not nesesary here, because the feedback wire can provide both The Timing of On and Off but also the minimum amperage needed for the Base to operate. The only thing is that if we don't use resistor at all we have to touch the Base and the positive input lead just ones and then the circuit get excited and continue by itself just with one Transistor. I will share another short video in the comments about this .