1d (edited) • Weight Loss
🧬💉How to Reconstitute AOD-9604 💉🧬
In this video, I break down the simple, step-by-step process for reconstituting AOD-9604 peptide powder for research use.
Whether you’re new to peptides or just need a refresher, I’ll cover the essentials to ensure proper mixing without damaging the compound or causing gelling. Remember, this is for informational purposes only—always consult a healthcare professional or follow manufacturer guidelines for any therapeutic applications.
What You’ll Need:
• AOD-9604 vial (e.g., 5mg lyophilized powder)
• 0.5mL acetic acid (AA) for initial dissolution
• 1.5mL bacteriostatic water (BAC) for dilution
• 2 Sterile syringes (3mL) and needles for drawing
• Alcohol swabs for sterilization
• Clean, sterile environment
Step-by-Step Reconstitution Guide:
1 Prepare Your Workspace: Work in a clean area. Wipe down surfaces and wash your hands thoroughly.
2 Sterilize Vial Tops: Use an alcohol swab to clean the rubber stopper on the AOD-9604 vial, the acetic acid vial, and the bacteriostatic water vial.
3 Dissolve with Acetic Acid: Draw 0.5mL of acetic acid into a sterile syringe. Insert the needle into the AOD-9604 vial at an angle and slowly inject the AA along the side to dissolve the powder without foaming.
4 Gently Mix: Remove the needle and gently swirl or roll the vial until the powder is fully dissolved. This helps prevent gelling issues common with AOD-9604.
5 Dilute with Bacteriostatic Water: Draw 1.5mL of bacteriostatic water. Slowly inject it into the vial along the side, again avoiding foaming.
6 Final Mix: Gently swirl until fully combined. Total volume: 2mL for a ~2.5 mg/mL concentration (adjust calculations if your vial size differs).
7 Inspect and Store: Check for clarity (the solution should be clear and particle-free—no gel). Refrigerate the reconstituted vial and use within the recommended timeframe (typically 30-45 days for BAC mixes).
Typical Dosing Notes (For Reference Only):
• Standard research dose: 300–500 mcg once daily, injected subcutaneously.
• Using a U-100 insulin syringe: For 2.5 mg/mL concentration (5mg in 2mL), 300 mcg = 12 units (0.12mL); 500 mcg = 20 units (0.2mL).
Safety First: Avoid contamination, use fresh needles, and discard if cloudy or gelled. This isn’t medical advice—research responsibly!
If you found this helpful, like, subscribe, and hit the bell for more peptide guides. Drop questions in the comments!
#AOD9604 #PeptideReconstitution #Biohacking #ResearchPeptides #HowToReconstitutePeptides #AOD9604Guide #PeptideTutorial
8
0 comments
🧬💉How to Reconstitute AOD-9604 💉🧬
powered by
skool.com/peptide-biohack-research-hub-9880
🧬Join Peptide Biohack Research Hub🧬Explore cutting-edge peptide research, biohacking strategies & protocols.Connect, learn, & optimize your health!
Suggested communities
Powered by