7d (edited) • General discussion
Stupid Mistake Yesterday 🙈
Lesson learned yesterday, I was at a job and they were pressing me for time as they wanted to leave by 5pm. I was printing on wooden boards and because I was rushing I forgot to set the lowest point and the print started higher up than they requested. Thankfully they said it’s not a deal breaker. Lesson: don’t rush and ensure you set your staring point correctly. Done lots of prints and it’s the first time I’ve made this error.
1
4 comments
Stupid Mistake Yesterday 🙈
powered by
skool.com/creators-of-tomorrow-2830
A supportive community for wall printers and newcomers, helping you design, print, sell, and run your own wall printing business.
Suggested communities
Powered by