Cannot believe after all these years this was my first ever attempt top coating a dragon egg like this. Previously it was applied on the lathe then I had to run the lathe for hours to allow the resin to cure to a stage it no longer runs if the lathe stops. With this method I can finish multiple eggs at the same time without running the lathe. This egg was only sanded to 80grit so saves also plenty of time

So this is my first crack at a river table, and I have some undulations as it's shown in the video, it seems to be anywhere that there was a hole like the river or holes in the wood. It's where the epoxy was deeper than the pour level over the wood. I think the problem is anywhere the pour was deeper it got a little hotter and it cooled differently. Maybe if I had poured a little deeper over the redwood. At any rate should I just lightly sand this and pour bar top over it or should I sand it all really level? I'm thinking it would be OK because bar top is self leveling. How do you feel about a coat of bar topper? Regards Jim. 🐐

I'm a member of the Arts of the Inland Gallery here locally to show and sell my works. I love watching David's Woodturnig videos I've learned from them

Going to give this one a go as my next project. Have the burl on its way, need to order the ZAP 5-Minute, and find some dried flower kits. Everything looks pretty self explanatory - any tips before starting?

Can you make a video on how to make these. Their beautiful!