Has anyone been able to change SW units so that it remains that when you relaunch it? I use MMGS, but its always a different one when I launch it. I tried searching online, but it only saves it in the model and not in the software.

Alright folks...hope every one is well...as i promised to share some of my work past or present, here are two one of my first full projects done awhile back (2014)...I rendered both in Keyshot...at the time, i wasn't very refined, but with practice comes confidence. For the F1 steering Wheel, i decided to revisit it and do a full scale functioning prototype...to be continued...

I recently finished my first project and as a mechanical engineer, I wanted to design something related to what I had studied. I found a tutorial on Youtube and designed this.. its a full design and assembly. Next up: Rendering

I finished the key tutorial. There were some things that wouldn't cooperate as presented, but workarounds were easy enough to figure out. Here's a picture of it. Just an Isometric this time.

Hello everyone, Its amazing how I was able to complete the first project as my first impression was that SolidWorks was very tough to learn. Tip: I would recommend not to watch the video and do the projects. I saw the whole video, then took a break for a couple of hours and then started the project. Onto the assembly now..