In my new bi-fold wallet build, I am ready to start on my cover. There are a couple of issues I need to address that I am not sure how to resolve. First is the issue of how much longer do I need to make the cover, to make up for the bend. Second is the stitching. How do I lay out my stitching so that my edges all line up together if one piece is longer than the rest? Third issue , I just realized is that I was wanting to line the cover, is that a new stitch line or can I use the same stitch line for the liner as I do the rest of the cover? I’m not sure how to photograph my concerns. There will be a gap in the stitching, between the cover and the inside compartments,I assume in the fold. Do I just continue to run my stitching along my cover until I reach the other section of the the inside compartments?