Hey everyone, can you advise any lifehacks how you approach modeling something based on gpt generated references? Even if you try to make them somewhat blueprintish they are still a bit off on different planes. Any thoughts would be helpful. thank you! Attached a picture as an example

Hey everyone, I am facing an issue with filleting sometimes and I couldn't figure out why. So I am following the car course now and after piping the surface and duplicating the edge and lofting it I start to see some gaps in lofted surfaces. And of course I am having an issue with filleting it after. Can you guide me to a proper direction please? What might be the reason for that? I followed exactly the process - imprint - rebuild - pipe - boolean - duplicate - loft with g0 I know that in these specific areas I am not supposed to fillet in these specific areas , but it's a good example and I face it in some other areas too