4d • General discussion
First Danni and some questions
Printed my first Danni duck today. It mostly went well, had one support fail on the back of the hair. It didn't end up too bad, I had supports from bed only because I didn't want to leave marks on the back. The big problem I had was getting the supports out from behind the ponytail. Does it really need supports there? And if not how do I keep it form putting them there? I finally got them out but it left marks of pink back there. Sorry for so many questions but I'm relatively new to 3D printing.
0
9 comments
First Danni and some questions
Suggested communities
Powered by