Aug 25 • General discussion
This 3D Printed Shoe Started as a Complete Failure 👟
I tried to 3D print an entire shoe.
The first run failed completely. The printer left little piles of plastic around the nozzle instead of a shoe. Root cause of failure being the temperature of the nozzle.
I started over. The next run made it through. It came off the printer covered in supports and rough around the edges, but it worked.
That is the part I enjoy: break it, inspect what happened, and run it again.
Would you wear a 3D printed shoe? Yes or no?
1
0 comments
This 3D Printed Shoe Started as a Complete Failure 👟
powered by
skool.com/failure-mode-lab-6055
Failure first. I test AI, break systems, find root causes, and build smarter solutions with automation, tech, and hands on projects.
Suggested communities
Powered by